Jlcooper sBOX8D Manual do Utilizador

sBOX8D / sBOX8RGPI Control Panel for eBOX & gBOXUser Manual

ConfigurationConfiguration of the sBOX is performed by the rear panel DIP switches. By default, the sBOX GPI Outputs can be selected by the Bank butto

eBOXThe eBOX has 24 GPI Outputs. Using the sBOX, they are accessed in three banks of eight GPI Outputs. The following table shows the mapping of th

The Bank Button on the front panel of the sBOX can determine the behavior of the large buttons on the sBOX. The sBOX allows switching between three b

gBOXThe gBOX has 48 GPI Outputs. Using the sBOX, they are accessed in six banks of eight GPI Outputs. The following table shows the mapping of the

The Bank Button on the front panel of the sBOX can determine the behavior of the large buttons on the sBOX. By default, the sBOX GPI Outputs can be s

Button ActionThe behavior of the GPI Buttons can be configured to act as a momentary switch or toggle switch. To change the behavior of the GPI Butto

OperationUsing the sBOX is straightforward. 1. If Bank switching is enabled, simply press the Bank Button until the desired bank of GPI Outputs is se

Using the GPI OutputsThe sBOX has a 9 pin D-Subminiature connector that has 8 GPI outputs. These outputs mirror the state of switch LEDs 1-8 on the f

The outputs of the sBOX GPI ports are CMOS. The output signal is referenced to pin 1 of the GPI Output Port. The GPI Outputs deliver 0 or +5 volts a

TroubleshootingIf for some reason the sBOX8 does not give you the expected results, take a moment to do some investigating. The most important concep

sBOX8D, sBOX8R, gBOX eBOX are trademarks of JLCooper Electronics. All other brand names are the property of their respective owners.sBOX8D/sBOX8R Use

JLCooper Electronics Limited WarrantyJLCooper Electronics ("JLCooper") warrants this product to be free of defects in materials or workma

Table of Contents...Introduction 4...

IntroductionThe sBOX8D and sBOX8R are companion products to the JLCooper eBOX and gBOX GPI Interfaces. The sBOX8D and sBOX8R connect to the eBOX and

sBOX VariationsThe sBOX is available in two form factors, the sBOX8D which is the desktop version and the sBOX8R which is the rackmount version. The

InstallationeBOXInstallation of the sBOX with an eBOX is straightforward. Simply connect the sBOX to the eBOX using the supplied cable as shown in th

gBOXInstallation of the sBOX with the gBOX is just as straightforward. Simply connect the sBOX to the gBOX using the supplied cable as shown in the i

Multiple sBOXesInstallation of multiple sBOXes with an eBOX or gBOX is similarly straightforward. Simply connect the sBOXes to the eBOX or gBOX in a

Rack MountingThe sBOX8R is designed to be mounted in a standard 19 inch rack. This can be accomplished by using the optional JLCooper Racktray. The